Industrial-data-systems IDS Scale Basic Manuale Utente Scaricare il pdf (Pagina 38)

Scale Basic 4.2E Reference

Netmode 103

Purpose: true if display is in Net mode.

Overload 115

Purpose: true if scale status = Overload

Positive 101

Purpose: true if previous calculation result was Positive.

Remarks: Also set by Get id and Make id to signal that the instruction was successful.

Printable 108

Purpose: true if the weight registers (Gross/Net) contain printable (handbook 44) weight.

Qstatus 110

Purpose: true if communications port 2 receives an ‘I’ status from a previous status request or if

communications port 2 receives a ‘V’ (valid weight) from a previously sent RQ message.

Remarks: Qstatus is used when multiple indicators are connected together in a network. The

networks are normally setup in a Master/Slave configuration.

The Master unit sends out status inquires [S] to the slave units. The slave units send back an [I]

if they are idle (Qstatus is turned ON) or a [B] if they are busy (Qstatus is turned OFF).

The Master units sends out an RT request to automatically read a slave units data registers

(including Gross and Net registers). The Qstatus flag is set if the slave units weight registers

contain printable (handbook44) weight.

Setpoint 1…15 1…15

Purpose: true if SetpointX is active.

Timer 1…5 41…45

Purpose: true if TimerX is active.

Tx2ready 114

Purpose: true if Com port 2 transmit is ready (not busy sending a previous message).

Zero 100

Purpose: true if previous calculation result was Zero.

Remarks: Also set by Get id and Make id to signal that the instruction was un-successful.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 52 53

Nessun commento

Modèles	Type de document
CaptureTV M205	Manuel de l'utilisateur Tekram Technology CaptureTV M205 User's Manual, 31 pages
M205	Manuel de l'utilisateur Tekram Technology M205 User's Manual, 32 pages

Industrial-data-systems IDS Scale Basic Manuale Utente Pagina 38